• %\Windows\System\cfg.exe
  
• %\config\cfg.exe [ Runs on Startup ]
  
• %\config\s-1-5-21-1482476501-1644491937-682003330-1013\cfg.exe
  • If you have any of these files in running process from task manger, end the process before removal.
  • Note: if task manager is disabled
    Download the following file[ Right click and select "Save Target as" ]
    Click to Download - Enable Registry.reg
    
  • Open it with Regedit.exe [%system32\regedit.exe], then it Confirms Add to registry Yes or No, Confirm Yes, then click Ok.
    

• Note: If the

• %\config [ Creates on Windows Installed Drive Root Folder ]
  
• %\config\cfg.exe [ Runs on Startup ]
  
• %\config\s-1-5-21-1482476501-1644491937-682003330-1013\cfg.exe
  
  • If you have any of these files in running process from task manger, end the process before removal.
  • Note: if task manager is disabled
    Download the following file[ Right click and select "Save Target as" ]
    Click to Download - Enable Registry.reg
    
  • Open it with Regedit.exe [%system32\regedit.exe], then it Confirms Add to registry Yes or No, Confirm Yes, then click Ok.
    

One of a new features in Windows 7 and Windows Server 2008 R2 is the ability to boot from a VHD.  It is pretty simple to enable this feature and have it ready at your disposal!  Before you begin you should note the following?

• You can only boot a Windows 7 or Windows Server 2008 R2 VHD
• You must configure the boot editor from a Windows 7 or Server 2008 R2 install
• You cannot use a Virtual PC VHD, I suggest a Hyper-V VHD
• You need to start with a clean slate, don?t try and reuse an old VHD

I am sure this will change as Windows 7 goes through the beta and RC stages on its way to RTM and we?ll update this as necessary but here goes?

Start by launching a Command Prompt and be sure to run as Administrator, once that is done run the following commands?

bcdedit /copy {current} /d ?Boot_From_VHD?

Copy the CSLID that is displayed and then run?

bcdedit /set [CLSID} osdevice vhd=[C:]\vhdname.vhd