First things first: My Canon EOS 5 and then 3 never fell apart on any hike. But then I hadn’t walked 160 miles with either in one go, but they proved to be tough cameras. So the Leica’s first outing on a hike through Surrey and Kent in South East England for 2 weeks around my neck covering at least 130 miles up and down on the trail and 30 miles to and from pubs, accommodation and around towns would give it a gruelling challenge.

The result was the M2 holding up perfectly apart from one screw going walkabout somewhere in Rochester probably.

It had always been loose, the one on the right on the top plate, it was loose probably due to the camera shop not tightening it properly – I should get it sorted, and will, but not having my M2 for even so much as an hour is a daunting thought! Otherwise the camera kept soldiering on, come wind, rain and an awful lot of shine. The beauty of a manual camera is there is no electronics for water to foul although you wouldn’t necessarily want to drench the M2 in a downpour as I’m sure it wouldn’t do much good in the long run.

The lenses were a slightly different ball game. First the Voigtlander Ultron, held up magnificently until day 11 of 14 when I noticed the back screw thread plate was working itself free. I can forgive it as it had a lot of stress and that would work screws free to an extent, this had the effect of getting the focussing helical (?) off kilter so that at infinity it was focussing beyond infinity if that makes sense. Also the focussing was slipping with the rangefinder coupling becoming uncoupled as the lens shifted a few tenths of an inch from its usual position. I assumed this meant adjustment under warranty but was advised by Robert White it would be a 4 week turnaround time, so I have tried adjusting it myself and will run a test roll and see whether it is indeed now OK.

My ‘new’ 50mm Canon Serenar (a gem of 1950s optical design, 50mm f/1.8 and pretty flare resistant and excellent colour rendition) managed to end up in two bits The front part which contains all the optics unscrewed from the rear part which is the barrel and rear screw mount. Screwing it back together tightly solved the problem. (It hadn’t been done when I received it and I had no idea how to adjust it as it has no externally visible screws, so it took it to fall apart for me to realise how its held together!)

Overall, I shot 13 rolls of Kodachrome, 1 roll of EBX and the camera did a grand job. Leica sent a replacement screw to me for free (which was unexpected!) so the M2 is visually all 100% again. That said, I found the elastoplast I had taped over the hole made a comfortable thumb rest, might keep it on!

That said, the Leica just kept on going. Just what I expect from a camera. They have tough lives with me, but they’re like working dogs – they appreciate it that way.